High speed USB modem with up to
8Mbps connection!
The Aztech DSL Turbo 100U ADSL Modem delivers seamless broadband Internet access at a high
transmission rate of up to 8Mbps (150 times faster than 56K modem). Blaze through the
Internet and call your friends simultaneously with just one phone line! The DSL Turbo 100U
is bus-powered, eliminating the need for any messy corded power supply. With its
hot-swappable feature, you can install and remove the modem without shutting down your
computer.
FEATURES / BENEFITS
Compliant to ADSL standards and recommendations
Worldwide deployment standard
Up to 150 times faster than 56Kbps modems when operating at optimum (note: subjected to
local ADSL service provider package)
Assured operability with DSL access network worldwide
Absolutely hassle free installation
Ensure best connection speed given a current telephone line condition
Easy future feature enhancement
Uses existing copper telephone lines
Bus powered, does not require external power supply
Simultaneous use of Phone and Internet on ONE phone line
USB hot swappable plug & play installation
PACKAGE INCLUDES:
Aztech DSL Turbo 100U High Speed Modem
Installation CD
Easy Start Manual
USB Cable
Telephone Cable
SYSTEM REQUIREMENTS:
IBM compatible PC or notebook
Pentium II 233MHz and above
USB port
32MB system memory
CD-ROM drive
Available hard-disk space
Windows 98, Windows 2000, Windows Millennium
NOTE:
Please check with your ISP or phone company for support ADSL Internet
connection
Telephone line conditions may limit your ability to connect at the highest speed
Technical specifications
The Aztech DSL100U is a Controllerless
Full-Rate USB ADSL modem. It uses Globespan's Titanium™ DSP solution that fully
complies to ANSI T1.413 Issue 2, ITU-T G.992.1 (G.dmt) and G.992.2 (G.lite) ADSL
standards. It supports Full-Rate ADSL transmission at up to 8 Mbps downstream and up to 1
Mbps upstream. It is interoperable with major DSLAMs and provides drivers to support all
major operating systems. This modem is targeted at residential market for its ease of
hot-swappable installation.
PRODUCT SPECIFICATIONS
ADSL/ATM Support
Controllerless-based External ADSL Modem
Hot Swappable Plug & Play and USB Specification 1.1 compliant
Multi-mode support : ANSI T1.413 Issue 2, ITU-T G.992.1 (G.dmt) and G.992.2 (G.lite)
Using Discrete Multi-Tone (DMT) line encoding scheme
Full Rate transmission at up to 8 Mbps downstream and 1 Mbps upstream
G.lite transmission at up to 1.5 Mbps downstream and 512 kbps upstream
Rate Adaptive modem at 32 kbps steps
Software upgradable via driver for future feature enhancement
Full RFC1483/RFC2516/RFC2364 protocol stack support
Bus Powered - No external power is required
Built in POTS filter (microfilter)
ATM Layer with Traffic shaping (UBR/CBR/VBR-nrt)
AAL ATM Attributes - AAL5
VPI Range (0-4095) and VCI range (1-65535)
F4/F5 OAM Send and Receive/Loopback supported
Trellis Coding and Echo Cancellation support
Encapsulation Support
RFC2364 PPP over ATM
RFC1483 Bridged Ethernet over ATM
RFC1483 Routed IP over ATM
RFC2516 PPP over Ethernet
CHIPSET
Anchor AN2131QC USB Interface
Globespan GS7070 ADSL DMT Modem and ATM Framer
Globespan GT3180 ADSL Analog Front End
ADSL MODEM DRIVER SUPPORT
Windows 98
Windows 98 Second Edition
Windows 2000
Windows Millennium
POWER REQUIREMENTS
Voltage : 5V DC
Current : 500mA
IN BUILT MICRO-FILTER
Used for separation of the ADSL And Telephone signals to prevent mutual
interference
Micro-filter is a passive device ensuring that in the even of power failure of any active
components, there will be no disruption to the telephone service
Line Side differential input blocking impedance
At 20 kHz >2k
At 30 kHz >3k
From 5 MHz to 10 MHz >4k
From 10 MHz to 400MHz >2k
1 kHz insertion loss between 600 Ohm resistive at < 0.7
1 kHz/2.8kHz slope between 600 Ohm resistive at < 0.8
DC resistance in Ohms (Tip to Tip, and Ring to Ring < 50, Tip to Ring >10M )
Longitudinal Balance per IEEE Method (From 200 - 1 kHz > 58dB, From 1 kHz - 3 kHz >
53dB
Envelope Delay 300 Hz - 2800 Hz is < 100 ms
MTBF
MTBF = 74,279 hours (BelStress V3.10 Reliability Prediction to BellCore Method
[TR-NWT-000332])
PTT Approvals
US (FCC Part 15, FCC Part 68, UL 1950 3rd edition)
Canada (cUL)
Europe (CE)
Singapore (iDA, EMC CE, CB IEC950)
China (CCIB and MII)
Malaysia (SIRIM)
EXTERNAL CONNECTORS
1 x RJ11 Telephone socket for Telephone line
1 x RJ11 Telephone socket for Telephone Handset
1 x USB port
DIMENSION
Dimension : 176.5 (L) x 118.9 (W) x 37.9 (H) mm
Weight : 280 g
ENVIRONMENTAL
TEMPERATURE
Operating :
10 to 45 Celsius
50 to 113 Fahrenheit
Non-Operating :
-25 to 70 Celsius
-13 to 158 Fahrenheit
HUMIDITY
Operating: 30% to 80% Relative Humidity (Non-Condensing)
Non-Operating : 10% to 95% Relative Humidity (Non-Condensing)
SYSTEM REQUIREMENTS
CPU : Pentium II 233 MHz or above with USB port.
Memory : 32 MB
System OS : Windows 98, Windows 98SE, Windows 2000 and Windows Millennium
Interface : USB Port
For ordering the product/s or for more information click here
|
Back to Aztech Product Index
